# if you dont/cannot use dvbapi-mode but want to connect for example from a local CCcam-client to your local Oscam it is configured via User = dvbapi # name of your choice but must be simmilar to the user configured in er # if you want to use dvbapi mode it can be enabled withīoxtype = none # none = autodetect, or use correct value for your receiver Folders/path should be available even if logging disabled (disablelog = 1) # path for usrfile/logfile/cwlogdir depend on your system. Waitforcards = 0 # should be 1 if you have also local cards read by Oscam Same config also works using Enigma2 GUI. I have one receiver (Pingulux with Neutrino OS) configured for Sky UK with the following config. Key = 0102030405060708091011121314 # I dont know why you x-out the key - this is the defauilt key given by the server, you cannot change it yourselfĪnd for german Sky programs on anther receiver of course with a different CS-account and additional readers:Īs there is this new Oscam section created in the forum (much appriciated as I use Oscam myself *g*) perhaps someone like some examples for configuration that works on this server. Protocol = newcamd525 # the entry newcamd should also be fineĭevice = ,portnumber # (all together, no blanks) My rver for Sky UK, the only available reader on the receiver:ĭescription = Sky UK HD + ViewAsia + ZeeTV 28E I am not sure when the account config was changed, but I think it was quite a while ago ~58xx version of Oscam I am using Oscam (>62xx) with the parameters user = and password = on this server since December, works fine
0 Comments
Leave a Reply. |